
Read the contour interval in the map margin, then count the gaps from a labeled line to the line you want. While you stay on one slope, each gap in the direction of travel changes the elevation by one interval. To compare slopes on that same map, look at how much horizontal distance it takes to cross the same change in elevation.
Find the elevation of an unlabeled line
Imagine a classroom map with a 20-foot contour interval. On the slope in the exercise, the labels tell you that you’re moving uphill from 800 feet toward 900 feet. Start at 800 and move across three gaps. The first new line is 820, the second is 840, and the third is 860 feet. The point you’re seeking is on that third line, so its elevation is 860 feet.
Count the spaces between lines. If you count the starting line as a step, you’ll put the result one interval too high. For a visual check of how contours represent ground shape, look at the paired illustrations in the University of South Carolina course handout based on USGS materials.
Compare two paths on the same hill
Measure each route on the map and use the bar scale to convert its length to a horizontal distance. Both routes in the example climb from the 840-foot contour to the 900-foot contour. One takes 300 feet of horizontal distance on the west side. The other takes 600 feet on the east side. The vertical rise is 60 feet on each. The west route gains that elevation in a shorter horizontal distance, so its average slope is steeper over the marked stretch.
Check the direction and the units
To count uphill, find a second labeled contour or spot elevation on the same slope. Add one interval per gap as you head toward the higher elevation.
Check the direction again if your route crosses a valley bottom, ridge, hilltop, or saddle. The next contour you meet can repeat the same elevation. Short ticks called hachures point into a depression. Once you are inside it, the elevation drops by an interval as you cross successive hachured contours inward.
Check the units in the margin. The example uses feet, and your map may use meters. Use spacing comparisons on the same map, where scale and interval are held fixed.
Label one contour on a course map
Choose a labeled contour on a map from class and write the elevation of a nearby unlabeled line. Then work backward from a second labeled line to see if you get the same value.